Skip to product information
1 of 1

premo! Tri-Color Cabochon Ring

premo! Tri-Color Cabochon Ring

Read More
This ring is cute and easy to make--the best of both worlds!
Read Less
ADDITIONAL SUPPLIES

7 small pieces of lace
3 small fresh water pearls
20 ga wire
28 ga wire
1 1/8” circle cutter
¾” circle cutter
Small artist’s brush
Round nose pliers
Chain nose pliers
Card stock
Bathroom tissue
Lace – see Designer’s note Step 2|7 small pieces of lace
3 small fresh water pearls
20 ga wire
28 ga wire
1 1/8” circle cutter
¾” circle cutter
Small artist’s brush
Round nose pliers
Chain nose pliers
Card stock
Bathroom tissue
Lace – see Designer’s note Step 2

View full details
Project Instructions
Getting Started
Polymer clay may stain. CLAY MAY DAMAGE UNPROTECTED FURNITURE OR FINISHED SURFACES. DO NOT USE polymer clay on unprotected surfaces. We recommend working on the Sculpey clay mat, wax paper, metal baking sheet, or disposable foil. Start with clean hands and work surface area. Knead clay until soft and smooth. For best results, clean your hands in between colors. Shape clay, pressing pieces together firmly. Bake on oven-proof glass or metal surface at 275°F (130 °C) for 30 minutes per ¼" (6 mm) thickness. For best baking results, use an oven thermometer. DO NOT USE MICROWAVE OVEN. DO NOT EXCEED THE ABOVE TEMPERATURE OR RECOMMENDED BAKING TIME. Wash hands after use. Baking should be completed by an adult.Begin by preheating oven to 275 °F (130 °C). Test temperature with oven thermometer for perfectly cured clay. For best results, condition all clay by running it through the Clay Conditioning Machine for several passes on the widest setting. Fold the clay in half after each pass and insert the fold side into the rollers first.
Make a teardrop of both Wasabi and of Ultramarine Blue. Make an "S" shape of Turquoise. The teardrops should be slightly smaller than the "S".
Push the three shapes together with the Turquoise in the middle. The Wasabi shape should be point down and the Ultramarine Blue shape should be point up.
Push the three colors together into the large round cabochon mold until they fill up the space and the seams are completely smooth all the way around the edge.
Push the ring finding into the colors until the outside edge of the clay starts to come up around the flat back of the finding. Push the edge of the clay over the flat back of the finding. Remove both the finding and the clay together from the mold.
Roll very thin ropes of Silver clay. Outline the edge of the circle with Silver clay. Trim the end and smooth the seam with your finger. Lay a line of Sliver between each color. Trim the ends. Make sure all the Silver ropes are well attached to the colors of clay. Bake according to directions above.