Sculpey Premo™ Sushi Roll Cane and Bracelet

Getting Started:

Please make sure your work area is covered and you are not working on an unprotected surface. We recommend working on the Sculpey® Oven-Safe Work Mat, wax paper, metal baking sheet, or disposable foil. Uncured clay may damage unprotected furniture or finished surfaces. Be sure to cover your crafting area appropriately.

Start with clean hands, unwrap and knead clay until soft and smooth, or condition by running clay though a Pasta Machine. We recommend using a designated machine for clay purposes only. When working with multiple colors, clean hands with soap and water or baby wipes (we have found that baby wipes work best) before switching colors. Shape clay, pressing pieces firmly together. Wash hands after use.

Baking:

Begin by preheating oven to 275 °F (130 °C). After you are done creating; for best results bake clay on an oven-proof surface such metal, aluminum foil, an index card or the Sculpey® Clay Mat at 275°F (130 °C) for 30 minutes per 1/4" (6 mm) thickness according to package directions. Oven safe glass or ceramic surfaces are also acceptable for baking; however please note that the baking times may take longer as the glass or ceramic surfaces take longer to heat up. For best baking results, use an oven thermometer. DO NOT USE MICROWAVE OVEN. DO NOT EXCEED THE ABOVE TEMPERATURE OR RECOMMENDED BAKING TIME.

Create sheets of your three lightest colors and stack these in order from lightest to darkest. Shown here are Bright Green Pearl on top, Peacock Pearl in the middle, and Cobalt Blue on the bottom. Reserve the Navy for later. Create long and narrow, about 6" long and only about 2"-3" wide. Starting at one end, make deep impressions in the clay stack with the dowel rod all the way across the stack. These grooves should be parallel with the short side of the stack. Depending on the look you would like to achieve, for this step you could substitute something thinner than a dowel rod, like the edge of a ruler, and you could experiment with making the grooves closer together or further apart. Trim the short ends of the stack when you are done making the grooves.

Pinch the stack flat on the two short ends. Sheet your fourth and darkest color on the #3 setting. Place it under the grooved stack. Trim the dark color so it lines up on three edges and extends past one of the short edges by 1/4 inch;. Wrap this extra 1/4 inch; around the short edge of the stack.

On the widest setting of the Clay Conditioning Machine roll 2 strips of Bright Green Pearl, one strip of Peacock Pearl and one strip of Navy . Place the strip of Navy on the bracelet, followed by the two strips of Bright Green Pearl.

Using various size circle cutter cut a random pattern of holes in the strip of Peacock Pearl. Create a random pattern using the smallest Style and Detail tool.