Free Shipping on all Orders Over $30.00 in the continental United States! We do not ship internationally or to PO boxes

Sculpey® Souffle Filigree Dangles

Starting at $10.99

Use some of your scrap clays to make these easy and lovely earrings. It only takes a bit of clay to dress up some metal filigree. And the filigree is so easy to decorate because it just grabs onto the clay.

Grouped product items
Product ImageProduct Name Qty
Liquid Sculpey® Multi-Pack - Primary
$10.99
Antique bronze filigree pieces (2)
Antique bronze ear wires (2) )
3mm Light pink heat set crystals (2) )
4mm Dark pink heat set crystals (2) )
Jewelry pliers)

Additional Resources

Getting Started:
Do not use unbaked clay on unprotected furniture or finished surfaces. Start with clean hands and work surface area. Good work surfaces include wax paper, metal baking sheet, or disposable foil. Knead clay until soft and smooth. For best results, clean your hands in between colors. Shape clay, pressing pieces together firmly. Bake on oven-proof glass or metal surface at 275 degrees F (130 degrees C) for 15 minutes per ¼” (6mm) thickness. For best baking results, use and oven thermometer. DO NOT USE MICROWAVE OVEN. DO NOT EXCEED THE ABOVE TEMPERATURE OR RECOMMENDED BAKING TIME. Wash hands after use. Baking should be done by an adult.
Begin by preheating oven to 275 degrees F (130 degrees C). Test temperature with oven thermometer for perfectly cured clay. For best results, condition all clay by running it through the clay dedicated pasta machine several passes on the widest setting. Fold the clay in half after each pass and insert the fold side into the rollers first.
You will need such a very little bit of patterned clay - this is the perfect project for using some decorative scraps. For my earrings, I sliced off the edge of a stacked piece I had left over from the Twisted and Curved Focal Bead project. My scrap clay already has very thin layers of colors stacked up making it perfect for a small Mokume Gane pattern. First I impressed two dots into the stack with the 2mm ball tool. Next I pressed the smallest circle cutter around the holes. Then I made radiating marks around the holes and through the circle with the plastic knife tool.
Loading...