Sculpey Premo™ Easy Silkscreened Pendant

Getting Started:

Please make sure your work area is covered and you are not working on an unprotected surface. We recommend working on the Sculpey® Oven-Safe Work Mat, wax paper, metal baking sheet, or disposable foil. Uncured clay may damage unprotected furniture or finished surfaces. Be sure to cover your crafting area appropriately.

Start with clean hands, unwrap and knead clay until soft and smooth, or condition by running clay though a Pasta Machine. We recommend using a designated machine for clay purposes only. When working with multiple colors, clean hands with soap and water or baby wipes (we have found that baby wipes work best) before switching colors. Shape clay, pressing pieces firmly together. Wash hands after use.

Baking:

Begin by preheating oven to 275 °F (130 °C). After you are done creating; for best results bake clay on an oven-proof surface such metal, aluminum foil, an index card or the Sculpey® Clay Mat at 275°F (130 °C) for 30 minutes per 1/4" (6 mm) thickness according to package directions. Oven safe glass or ceramic surfaces are also acceptable for baking; however please note that the baking times may take longer as the glass or ceramic surfaces take longer to heat up. For best baking results, use an oven thermometer. DO NOT USE MICROWAVE OVEN. DO NOT EXCEED THE ABOVE TEMPERATURE OR RECOMMENDED BAKING TIME.

Roll out a sheet of Bright Green Pearl. Place the silkscreen shiny side down on top of the clay sheet. 

Squirt a line of pearl paint across the top of the Flowers screen area.

Carefully and evenly drag the paint across the screen with the squeegee.

Squirt a line of black paint across the top of the Lattice work screen area. Carefully and evenly drag the paint across the screen with the squeegee. Peel the silk screen up from the corner and immediately place it in a basin of water. Clean the screen as soon as possible with water so that you can use it again and again. Blot it dry with paper towels.

Allow the screened paint to dry completely on the clay. Cut out a circle around the pearl flowers that matches the outside dimension of the screened area. Cut out a .5” circle from the Lattice Work screened area.

Press the flower design onto the largest dome of the Hollow Bead Maker. Make sure it follows the shape of the dome and that no air bubbles are trapped between the clay and the dome.

Place the small circle on top of the large disk and press it into place.

Roll a little ball of Purple Pearl. Pick it up with the small Etch ‘n Pearl and position it in the center of the design as shown.

Use the Etch n Pearl or a Dual Ended Detail Tool to poke a hole in the green disk where you would like to place the jump ring later. This will be the top of the pendant. Bake the pendant on the Hollow Bead Maker following the baking instructions for Premo.

When the clay piece is completely cool, carefully pop it off of the Hollow Bead Maker with your fingertip. Hook the toggle and the loop to either end of the chain with the small jump rings. Place the toggle through the loop. Use the larger jump ring to hook the clay pendant to the loop and close it with pliers.