Liquid Sculpey® Greige Granite Quick Gift Tag

Getting Started:

Please make sure your work area is covered and you are not working on an unprotected surface. We recommend working on the Sculpey® Oven Safe Work Mat, wax paper, metal baking sheet, or disposable foil. Uncured Liquid Polymer Clay may damage unprotected furniture or finished surfaces. Be sure to cover your crafting area appropriately. - Stir Liquid Sculpey® completely. Thin with Sculpey® Liquid Clay Softener as needed - Wash hands after use (we have found that baby wipes work best)

Baking:

•It is important to use oven thermometer when you bake the liquids so that you can ensure your oven is at the correct temperature.•Do not microwave the liquids. They must be baked in a Preheated oven at 275 ºF (130 ºC) for liquid colors and 300 ºF (149 ºC) for Clear – Do not exceed baking temperatures.•If your piece is less than 1/4” bake for 15 minutes. For thicker pieces that are 1/4” or above bake for 30 minutes. •If your liquid project has become yellowed or discolored in the oven, when you remake it, tent it by placing either – folding an index card in half and placing your project under it or by using aluminum foil over your project.

Stir the Greige Granite Liquid Sculpey (LS) with one of the purple tools. Fill the frame area of the large circle shape in the Bezel Mold with Greige Granite LS. Use the Needle Tool to stir the LS around in the edges of the frame area to make sure the LS fills the corners completely.

Fill the rest of the Bezel shape with the Greige LS completely and bake following the baking instructions for LS.

Stir the Rose Gold LS with one of the purple tools. Fill a heart shape in the Whimsy Mold with the Rose Gold. Tap the mold gently on the table to release bubbles. Bake the mold following the baking instructions for LS.

When the molds are completely cool, remove the pieces by gently flexing the molds. Write “for you” in the center of the bezel circle. Poke a hole in the top of each the heart and the circle bezel with a heavy needle or pin drill or Dremel drill. Tie the two pieces together with the raffia.