Free Shipping on all Orders Over $30.00 in the continental United States! We do not ship internationally or to PO boxes

Liquid Sculpey Adorable Paw Print Earrings

The Sculpey pet/baby silicone mold combines with the Sculpey Liquid Clays to create a pair of eye catching earrings! Design by Teresa Pandora Salgado  
Grouped product items
Product ImageProduct Name
No options of this product are available.

Additional Resources

Getting Started:Do not use unbaked clay on unprotected furniture or finished surfaces. Start with clean hands and work surface area. Good work surfaces include wax paper, metal baking sheet, or disposable foil. DO NOT USE MICROWAVE OVEN. DO NOT EXCEED THE ABOVE TEMPERATURE OR RECOMMENDED BAKING TIME. Wash hands after use.
Using your three metallic Liquid Sculpey colors with the Pet/Baby mold, make four small and two large paw shapes. Preheat the mold unfilled in oven for 5 minutes at 275 °F (135 °C). Carefully remove the mold from the oven. You can allow the mold to cool down until it is easy to handle, but still warm. Squeeze Liquid Sculpey Bakeable Medium into the mold, just to the top edge. Use squeegee to remove any excess Liquid Sculpey. Tap the mold to check for air bubbles. Pop all air bubbles. Bake for 10 minutes at 275 °F (135 °C). Let cool before removing the pieces.
Using the Sculpey piercing tool, poke a hole through the top center of the paws. Insert a jump ring into each hole. Pierce a pilot hole into the bottom of two large and two small paws. Insert the eye screws with just a tiny dot of Superglue on the tip of each screw. Add a rhinestone to the large paws with Superglue. Allow to dry.
Connect the paws to each other and to the ear wires with the remaining jump rings. Warning: You’ll be mobbed by jellie pet parents at the dog park!