Sculpey III and Liquid Sculpey combines with the Whimsy Silicone Mold by Sculpey so you can make wings for any of your favorite critters. No more waiting for pigs to fly!

TIME TO MAKE:
70 minutes with baking

Designer’s Note – For molds that have a lot of very small details, I prefer a Warm Cure method. Preheat the oven to 300 degrees F and place the mold inside. While the mold is pre-heating, make sure your liquids are thin and flowing. Stir the Clear Liquid Sculpey® completely making sure any lumps in it are broken up and completely mixed in. Remove the heated mold from the oven and allow it to cool for 2 minutes. Carefully touch the mold with your hand. If you can touch the mold comfortably with your hand and feel that it is still quite warm, it is ready to fill. Pour the Clear Liquid Sculpey® into the mold but don’t overfill. Carefully lift the mold and holding the mold filled side up, flex the mold slightly from the bottom, especially where the tiny details are. This will open up these details and help the liquid to run into them. When you are sure that the details are filled with liquid, back fill the mold completely and squeegee off excess. Tap the filled mold on a flat smooth surface to release air bubbles.