Bee's body is egg shaped, approximately 1" long. Cut a small piece of wire and insert into the top of the body
The bee band is 1/16th of an inch wide and wrapped around the lower half of the body
The arms are tapered logs bent into an "L" shape. The left hand is wrapped around a toothpick. Attach the Arms to the bee's body.
Dab white glue to the bee's bottom and press on the glass handle. Dab glue to the bee's right hand and press against the glass.
Poke 2 holes into the bottom of the body where the "legs" go in.
The boots are thick tapered logs bent into an "L" shape. Dab an end of the rubber tubing and insert into the boot. Set aside
The head of the bee is an egg shape. The nose is an oval shape. Press it on the head and insert 2 seed bead eyes. Attach the head to the body. Blush the cheeks.
1 small ball is attached to the ends of the antennas and insert into the bee's head.
The back button is an oval shaped piece of clay with 2 "button holes". Bake unattached to the bee.
Bake everything following manufacturer's instructions.
While the parts are baking, punch out 2 hearts.
Once everything's cooled, super glue (or use E6000) the wings to the body and then the button over the inner wing tip. Bend the antennas a little.
